top of page
How to assemble the Gecko V case
  • Arrange the top plate, bottom plate, front plate, and back plate as shown above.

  • Fastened with 12 M3x8 (Chassis Screws) screws.

  • If assembled correctly, it will look like the picture above.

M4

M4

M4

M4

Sub Connector

Main Plate

  • Place the main plate cover as shown in the picture. 

  • Use M4x10 screws (Chassis Screw) to fasten the corners, the remaining 4 are M3x8 to the Sub Connector.

  • The Sub Connector could be twisted while screwing. Use your hands to support it from the inside while tightening the screws.

  • Install 10 brass stand Off positions as shown in the picture by using M3x8 screws (Chassis Screws) from the other side.

  • Hold the Stand Off with one hand and the M3 screw in the other, tight with number 2 wrench.

  • Install I/O Shield

  • Install the mainboard using 10 M3x6 screws.

  • If some mounting holes are found overlapping, First loosen the screws on the back of the case and screw it back after installing the mainboard.

Plug Cover

  • Install the SFX or SFX-L PSU as shown in the picture using 4 6-32 screws.

  • Install Plug Cover as shown in the picture by using 2 pieces of M3x6.

SSD

SSD

SSD

SSD

Radiator Bracket

  • Install the SSD by attaching it to the SSD Bracket and attaching it to the main plate plate using T-Nut and M3x12 screws.

  • Install a 360mm radiator by attaching it to the Radiator Bracket as shown in the picture using the screws that come with the radiator kit. Then attach it to the main plate with 6 M3x8 screws (blue arrows).

Horizontal GPU Lock

PCIe Cover

  • To install the GPU horizontally, attach the Horizontal GPU Lock as shown using two M3x12 screws. 

  • Secure the GPU to the Horizontal GPU Lock with M3x6 screws.

  • Close the gap with the PCIe Cover using M3x6 screws.

Riser Cable Bracket

  • To install the GPU vertically, insert the 200mm Riser Cable into the Riser Cable Bracket and attach two 6.0mm Brass Stand Off as shown. Secure the Riser Cable to the Bracket with two M3x6 screws.

  • Attach the Riser cable bracket to the Main Plate with 3 M3x8 screws as shown in the figure.

Vertical back plate

Vertical GPU Lock

PCIe Cover "V"

  • Install the Vertical back plate as shown in the picture with 4 screws M3x8.

  • Plug the GPU into the PCIe slot on the Riser Cable, then secure the Vertical GPU Lock with two M3x8 screws.

  • Secure the GPU to the Vertical GPU Lock with M3x6 screws. Cover the gap with the PCIe Cover "V".

Pump Bracket

D5 Pump

DDC Pump

  • If using a D5 pump, first attach the pump to the Pump bracket, then attach the Pump bracket to the back of the case with four M4x12 screws.

  • If using a DDC pump, secure the pump directly on the back of the case with 4 M4x12 screws.

  • At the bottom of the case hold two 120mm fans using the M5 screws that come together with the fans.

bottom of page